Alien blaster fall out 48/29/2023 ![]() ![]() the top of the barrel has some extra details that you need a precision piece from your dremil kit to get that detail in. The barrel was pertty straight forward I used the lathe to make to cylinders and a slightly larger piece that will be the top and bottom of the barrel. Once that was finished I put rings of milliput around it to make the grip. Once all the holes were finished I attached the handle to the bottom of the casing and slotted a block of grey foam over that so I could then sand that into the finished handle. ![]() The buttons and dials were made using the lathe as well. After that I I marked out where I had to cut out all the openings to slot in the buttons, dials and the handle using the Dremil. Once I had the two halves finished and they fitted together I then put both pieces into the vac form to get a clean smooth look. The casing was made in two halves that were made of gray foam and sanded it down using sand paper.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |